http://chairsoft-press.com All the airsoft you could want, without leaving your chair Fri, 27 Jan 2012 03:05:54 +0000 hourly 1 http://wordpress.org/?v=3.3.1 http://chairsoft-press.com/reviews/gear/madbull-ultimate-hop-up-review/comment-page-1/#comment-58645 Brian Priest Wed, 29 Jun 2011 20:47:33 +0000 http://chairsoft-press.com/?page_id=2812#comment-58645 I WAS ABOUT TO BUY ONE OF THESE UNITS. NOW, AFTER READING HOW MUCH HASSLE IT IS TO FIT SOMETHING THAT SHOULD JUST SLIDE INTO PLACE I SHALL NOT WASTE MY MONEY ON THIS P.O.S. I WAS ABOUT TO BUY ONE OF THESE UNITS. NOW, AFTER READING HOW MUCH HASSLE IT IS TO FIT SOMETHING THAT SHOULD JUST SLIDE INTO PLACE I SHALL NOT WASTE MY MONEY ON THIS P.O.S.

]]> http://chairsoft-press.com/reviews/gear/madbull-ultimate-hop-up-review/comment-page-1/#comment-51942 Blaze Wed, 25 May 2011 20:49:47 +0000 http://chairsoft-press.com/?page_id=2812#comment-51942 I will personally say if you have a 2 pice hop-up? fialing down of the gun will have to be done. i went thru this wit my stag15 by echo1. heard this hop-up was legit....proved me wrong. I had to trim small perts of the lower receiver just to fit this into place & not only that. BB's would not feed into the chamber so i had to take a wire brush to take care of that due to the tracer unit mount a few metal bars wer sticking thru....not only that but where they shaped the inside close to the knub? i had to fial that down as well....So far after that what happend next? the Bucking is stopping the bb's from continuing thru the barrell....so i had to trip a little off the bucking.....im giving this an overall rating of - 2. I will personally say if you have a 2 pice hop-up? fialing down of the gun will have to be done. i went thru this wit my stag15 by echo1. heard this hop-up was legit….proved me wrong. I had to trim small perts of the lower receiver just to fit this into place & not only that. BB’s would not feed into the chamber so i had to take a wire brush to take care of that due to the tracer unit mount a few metal bars wer sticking thru….not only that but where they shaped the inside close to the knub? i had to fial that down as well….So far after that what happend next? the Bucking is stopping the bb’s from continuing thru the barrell….so i had to trip a little off the bucking…..im giving this an overall rating of – 2.

]]> http://chairsoft-press.com/reviews/gear/madbull-ultimate-hop-up-review/comment-page-1/#comment-9343 Madbull Ultimate Hop-Up Review « Chairsoft Press Thu, 10 Jun 2010 07:35:56 +0000 http://chairsoft-press.com/?page_id=2812#comment-9343 [...] range from your M4?  The Madbull Ultimate Hop-Up Unit might be just what you need.  Check out our review to read [...] [...] range from your M4?  The Madbull Ultimate Hop-Up Unit might be just what you need.  Check out our review to read [...]

]]>